Boiler used to pay attention when things

Pressure must not be too high, from 1.2 to 1.5 is the most suitable range will be reduced over the life of the seal member, the pressure is too small does not start phenomenon occurs, the solution is to open the release valve drain, open water switch Water was added.

Water

Bathing and washing dishes, we are using the stove hot water function. We used to feel when blended with water and heat on cold water, in fact, the child is doing wrong, stove heating hot water is not directly come, so we blended with cold water at the same time to change the pressure within the system cycle with hot, This change in pressure sensing device will be passed by the respective circuits and chips, the stove will warm rearranged according to a preselected operating mode for each device, so the device will accelerate the aging of repeated, according to the individual circumstances of the temperature setting on it.

Clean

If you find that tap water is getting smaller, the problem may occur on the faucet, the solution is very simple, is to let off under the faucet filter, removing impurities OK, because there are a lot of impurities in the water, such as: small stones , lines, grass, etc., so the boiler water is not drinkable, especially at home with the child's friends.

Maintenance

Spring without heating, the heating of the water should be let go, and inject new water.

The water switch is open when pressure is applied to two closed (pressure not more than three);

Open the last set of radiator release valve A with a strange taste "old water" will spout;

And other "old water" does not spray or flow out, close the release valve, the second pressure switch to turn on the water 2 or 3;

Repeated N times and processing water discharge, to your own satisfaction (Do not deceive yourself, this is something we own, repair up to a lot of silver yo);

Decided not to after repeated washing, the last time the pressure must not exceed 1.5 (maximum of 2).

When fall and winter again be a wash and change the water, but the pressure must not exceed 1.5, when the pressure is too high to open the last set of radiator release valve and release some of the water on the line.